Parts and Accessories
RockGARD carries a variety of products to modify our your RockGARD, Mud flap, Quietite, or other RockGARD product to ensure they work perfectly for your boat and trailer.
When sizing for a RockGARD, check the dimensions of the trailer side rails.
If the trailer frame side rail height is taller than 5”, you will need to add an upgraded hardware kit for proper installation. The upgrade kit can accomodate frames between 6” and 8” tall.
If the trailer frame side rail width is wider than 2” you will need the upgrade kit. The upgrade kit contains two sets of carriage bolts to accomodate trailer frame widths up to 5” wide.
There are versions for standard and XLong RockGARDS. The XLong kit contains additional mounting brackets for the XLong’s additional support poles.
The Alternate Centre Post System is used to mount the RockGARD to the trailer’s winch stand. On trailers where the tongue is too short to accomodate the typical center pole and bracket, this alternative system will still allow the RockGARD’s panels to be mounted.
The 24” Spreader Bar is used on trailers with extended tongues. When the side posts of the RockGARD can not be mounted to the trailer frame, the Spreader Bar is used to provide attachment points.
Single Ball Mount with the QUIETITE™ Wedging Shank
7,500 / 750 lb. GVWR / TW, per SAE J684 / V-5
1” Longer Shank for some hitch mounted mud flaps
Fits into a 2” hitch receiver
2” Drop
Powder Coated
With Pin & Clip
Eliminates looseness and instability between the receiver and ball mount shank
Stabilizes hitch mounted mud flaps
Single Ball Mount with the QUIETITE™ Wedging Shank
5000 / 500 lb. GVWR / TW, per SAE J684 / V-5
Fits into a 2” hitch receiver
4” Drop
Powder Coated
With Pin & Clip
Comes with Hitch ball
Eliminates looseness and instability between the receiver and ball mount shank
Stabilizes hitch mounted mud flaps
Single Ball Mount with the QUIETITE™ Wedging Shank
5000 / 500 lb. GVWR / TW, per SAE J684 / V-5
Fits into a 2” hitch receiver
8” Drop
Powder Coated
With Pin & Clip
Eliminates looseness and instability between the receiver and ball mount shank
Stabilizes hitch mounted mud flaps
Single Ball Mount with the QUIETITE™ Wedging Shank
7,500 / 750 lb. GVWR / TW, per SAE J684 / V-5
Fits into a 2” hitch receiver
2” Drop
2” Diameter Chrome Plated Ball
Powder Coated
With Pin & Clip
Eliminates looseness and instability between the receiver and ball mount shank
Stabilizes hitch mounted mud flaps
Single Ball Mount with the QUIETITE™ Wedging Shank
5000 / 500 lb. GVWR / TW, per SAE J684 / V-5
Fits into a 2” hitch receiver
6” Drop
Powder Coated
With Pin & Clip
Eliminates looseness and instability between the receiver and ball mount shank
Stabilizes hitch mounted mud flaps
Tri Ball Mount with the QUIETITE™ Wedging Shank
Variable load ratings depending on the ball size
Fits into a 2” hitch receiver
1 7/8”, 2”, & 2 5/16” Balls
Powder Coated
With Pin & Clip
Eliminates looseness and instability between the receiver and ball mount shank
Stabilizes hitch mounted mud flaps